This problem regularly occurs when cutting with CorelDRAW 3, 4 and 5, especially when cutting small characters. If you are using one of these Corel versions, the page size is limited to 27in. Therefore you must design with factor 1:10 or other similar factors. You can reduce these problem by setting textelements as large as possible, because CorelDRAW converts text to curves only as well as is necessary for printing. |
Note: The larger the original size of the text is, the better the conversion and thus the output quality is.
If this does not lead to the desired result, the only other alternative is to reset the text using EuroCUT.